lundi 18 novembre 2013

Ajout/Modification de filtres d'accrochage aux objets sur AutoCAD Mechanical

Impossible de s'accrocher sur une cote sur AutoCAD Mechanical?

Vous pouvez configurer les accrochages aux objets de manière à ce qu'ils ne prennent pas en compte les entités d'une zone sélectionnée du dessin.
Pour modifier ou créer un filtre, il faut aller dans Options puis sur l'onglet AM : Préférences. Cliquez ensuite sur Valeurs par défaut.



Cliquez sur Options de filtre dans la boîte de dialogue Configuration de l'accrochage avancé.



Décocher le filtre COTE. IMPORTANT  : Ne supprimez pas ces filtres.
Vous pouvez également créer ou modifier les filtres en entrant les valeurs nécessaires.


Pour plus d'infos, n'hésitez pas d'aller sur l'aide en ligne Autodesk 


mardi 23 juillet 2013

Pb démarrage Inventor avec office 365 !!!! voir Office tout court

Voici la procédure pour corriger le problème !!

Installing Office 365 will remove a local copy of VBA 7 module and prevents Inventor 2014 from working properly
If you cannot work properly in Inventor 2014 after having installed Office 365, follow the steps described in the solution below for solving the problem.
Issue
Installing Office 365 will remove a local copy of VBA 7 module, leading to the following:
·  Error messages are shown during Inventor 2014 launch
·  Unable open any document from Inventor 2014
·  Error messages are shown when executing VBA commands from AutoCAD
Solution
Standalone:
Close Inventor session and manually install VBA7 from Inventor source media:
64-bit 
Install VBA7 from "3rdParty\x64\VBA\Vba7.MSI" .
32-bit
Install VBA7 from "3rdParty\x86\VBA\Vba7.MSI" .
Deployment:
64-bit
Deploy VBA7 installer to the client from "3rdParty\x64\VBA\Vba7.MSI".
32-bit

Deploy VBA7 installer to the client from "3rdParty\x86\VBA\Vba7.MSI".